![\"just](\"http:\/\/saideira.net\/wp-content\/uploads\/2015\/03\/just-before-decking.jpg\")
<\/a><\/p>\n<\/p>\n
I decided that the I was going to add a composting toilet to my port hull. They are taller then a porta potty and basically I decide to sacrifice the aft bunk. Instead I get a nice lazaret. \u00a0for stowing lines and bumpers and a nice place for the battery and electrical panel. In this same picture you can see the shelf between frame 2 and bulkhead 6. The shelf is structural and adds a lot of stiffness to \u00a0the gunnel at that area<\/p>\n
The floor and floor supports. The floor is structural in that it adds support for the keel below<\/p>\n The forward bunk and bunk supports<\/p>\n Details on the lazaret framing. note the slope of the frame to allow water do drain. I left the deck edge frame in place to make it easier to lay the deck. it will eventually be cut out and become part of the hatch.<\/p>\n Some more details on the aft section. The rudder post reinforcement and another reinforcement just forward of it were I expect to have a vent. Hidden behind that you can barely see the spinnaker \u00a0block pad.<\/p>\n <\/p>\n","protected":false},"excerpt":{"rendered":" So before you actually add the deck, you really need and want to take care of some details. Here is the picture of the hull right before decking I decided that the I was going to add a composting toilet to my port hull. They are taller then a porta potty and basically I … Continue reading All things before decking…<\/span> <\/a><\/p>\n<\/a> <\/a><\/p>\n<\/a> <\/a><\/p>\n<\/a><\/p>\n<\/a>This is also a good time to make sure you have all the bow hardware reinforcement \u00a0pads and whatever hardware you have installed before decking the bow.<\/p>\n<\/a><\/p>\n